Company Details

  • Mighty Grass Co., Ltd.

  •  [Hebei,China]
  • Business Type:Manufacturer
  • Main Mark: Americas , Asia , East Europe , Europe , Middle East , North Europe , Oceania , Other Markets , West Europe , Africa , Worldwide
  • Exporter:31% - 40%
  • Certs:ISO14001, ISO9001, REACH, RoHS, Test Report
Inquiry Basket ( 0 )

Mighty Grass Co., Ltd.

Home > News > Construction technology of artificial lawn site
News

Construction technology of artificial lawn site

Artificial turf is rich in variety, adjustable in length and easy in construction. It can be laid in asphalt and cement fields. The following precautions are as follows: before stickup, the surface of the seam cloth, the bottom of the lawn and so on are clean, dry and water free. It is not suitable for wet rain and snow and other bad weather. The construction of the working environment should be suitable for construction between 0-40 degrees centigrade, otherwise it will lead to poor adhesion.
The concrete steps of the artificial lawn site are as follows:
1. Glue and glue:
The brush is applied to the bottom of the lawn with a thick and uniform brush, and it can not be repeatedly coated with glue. Otherwise, it can cause the bubble phenomenon or even fall, strictly control the thickness of the glue, pay attention to the proper coating speed, and apply it to the adhesive two adhesive surface respectively.
According to the temperature, humidity and other conditions at that time, the reasonable control of the airing time is generally suitable for 10-15 minutes with glue, and eight or nine into dry glue. When bonding requires a one-time alignment of cement. It is not necessary to move the bonded object back after bonding.
2. Pressure curing:
After bonding, remove the surface debris, and use special rubber hammer to hammer the edges from the bonding point to the two sides, so that the surface is fully bonded and denser. The curing time is usually three days, and the final strength is usually ten days. Therefore, during curing, we should pay close attention to its maintenance, avoid excessive exposure, water invasion and movement, so as to achieve the best bonding state.
3, cutting and recuperation:
After bonding before filling and rubber particles on the cutting site of quartz sand debris cleaning.
4, filled with quartz sand:
After the lawn pasting, it is necessary to fix the grass seedlings with special stone sand, so that the grass seedlings are not lodged, and the remaining height of the grass seedlings is less than 10mm, and the rubber particles are spread on the surface of the grass seedlings, and the spread should be evenly spread, and the sand grains with the angle of the grass should not be perfused to prevent the athletes from being hurt.
5. Inspection and acceptance:

Through the above steps, the lawn is laid basically. Finally, the lawn should be checked and checked as a whole. If problems are found, it should be reported and corrected in time.

14 6 2 Putting Green Artificial Grass 02

Share to:  
Communicate with Supplier?Supplier
Abner Han Mr. Abner Han
What can I do for you?
Contact Supplier